1350 Non CV Yoke - 32 spline, NVG241OR without Speed Sensor
Part #1949 -- $75.00
This 1350 Non-CV yoke is for NVG241OR transfer cases NOT equipped with a speed sensor mounted in the tailhousing. This new yoke uses U-bolts instead of problematic straps and can be used on the front or rear output shaft.
A new factory specification dust shield is installed onto the yoke so that the original oil seal functions correctly. We strongly recommend using the dust shield since it can be easily replaced as normal wear occurs from the seal lip. There are some replacement yokes on the market for the 241OR that do not use the dust shield and force disposal and replacement of the entire yoke once the seal surface is worn (very costly).
The rear spline area of the yoke has been counterbored (see below) to fit the stock transfer case output shaft. The yoke is coated with black oxide to prohibit rust.
The front spline area of this 1350 yoke has also been counterbored (see below) to properly seal against the large shaft O-RING (see below) found only on the Jeep JK application transfer case. Some other companies ignore this detail to allow use of one yoke for all applications. The new yoke is coated with black oxide to prohibit rust. This is another feature not offered by other companies.